ASSEMBLY10Reflector (#2) is comprised of 3 – outer pieces and 1 – center piece. Locate all 4 pieces of Reflector (#2) which are wrapped in bubble wrap
Step 8 Attach the reflector to the top head assembly:Attach 3pcs M8 washers on the top of 3pcs double pointed bolts. Place assembled reflector on the
Step 10 Put the cylinder on the base:bolts and tighten it in order to prevent the cylinder from moving.Warning: The cylinder used must include a colla
Step 12 Lower the cylinder cover onto cylinder base. Step 13 Disconnect cylinder when storing or transporting: 1. Turn off the heater. 2. Turn off
WARNING: DO NOT attempt to operate heater until you have read and understood all precautions. Failure to do so can result in serious personal injury
CAUTION: Avoid inhaling fumes emitted from the heater’s first use.Smoke and odor from the burning of oils used in manufacturing willapper. Both smoke
WARNING: WHEN CERTAIN MATERIALS OR ITEMS ARE LEFT ABOVE, BESIDE, OR UNDER THIS HEATER WHILE IN USE, THEY WILL BE SUBJECT TO RADIANT HEAT AND COULD B
In a salt-air environment (such as near an ocean) corrosion occurs more quickly than normal. Frequently check for corroded areas and repai
MAINTENANCE / STORAGE NOTE:STORAGE: Between uses: Turn the control knob to “OFF” position. Turn LPG cylinder to “OFF” position. Store
PROBLEM PROBABLE CAUSE SOLUTION Gas valve may be OFF Turn the gas valve ON Fuel tank empty Refill LP gas tank Orifice blocked Clean or replace
Tools neededAdjustable opening 8’’longPhilips head screwdriverLeak detection solution (instructions on how toFor questions, replacement parts, service
●●●●●●●●●●●●●●●●●●●●●●●●PARTS1 Center Reflector Cap3 Reflector Pieces1 Head Assembly1 Gas Hose (attached to Regulator 19)1 Upper Post1 Lower Post1 Cyl
NOTE: PLEASE READ THE FOLLOWING SAFETY RULES WARNING:This appliance must only be used outdoors.Using this product in an enclosed area may causeinjury,
ATTACHING WHEEL ASSEMBLY Step 1 1-1. Locate Wheel Assembly (24) and 2 nuts/bolts contained in plastic bag with Wheel Assembly (Fig. 1). Step 2 2-
WARNING:Proper assembly is the responsibility of the installer.Step 1 AttachAttach 3pcs LPG cylinder fixed parts on the basewith 6pcs M6x12mm bolts. p
Step 2 Attach post support to post mounts: Step 3 Attach lower post to base assembly: Attach the lower post to the post mounts using 4pcs M6x10
Step 4 Attach upper post to lower post: Screw the upper post to the lower post as illustrated by turning in a clockwise direction until securely tig
Step 6 Attach double pointed bolts to head assembly: Attach M8x90 double pointed bolts (3pcs) to head assembly.Step 7 Attach the gas hose to head as
Kommentare zu diesen Handbüchern