ASSEMBLY10Reflector (#2) is comprised of 3 – outer pieces and 1 – center piece. Locate all 4 pieces of Reflector (#2) which are wrapped in bubble wrap
Step 8Attach the reflector to the top head assembly.Attach 3pcs M8 washers on the top of 3pcs doublepointed bolts. Place assembled reflector on the to
Step 10Put the cylinder on the base, and into the fixedcylinder round. bolts and tighten it in order to prevent the cylinderfrom moving.Warning:The cy
Step 12 Lower cylinder cover onto cylinder base Lower the cylinder cover onto cylinder base. Step 13 Disconnect cylinder when storing or transport
WARNING: DO NOT attempt to operate heater until you haveread and understood all precautions. Failure to do so can result in serious personal injury, d
CAUTION: Avoid inhaling fumes emitted from the heater’s first use.Smoke and odor from the burning of oils used in manufacturing willapper. Both smoke
WARNING: WHEN CERTAINMATERIALS OR ITEMS ARE LEFTABOVE, BESIDE, OR UNDER THISHEATER WHILE IN USE, THEY WILLBE SUBJECT TO RADIANT HEAT ANDCOULD BE SERIO
In a salt-air environment (such asnear an ocean) corrosion occursmore quickly than normal.Frequently check for corroded areasand repair them promptly.
MAINTENANCE / STORAGENOTE:STORAGE:Between uses: Turn the control knob to “OFF” position.Turn LPG cylinder to “OFF” position.Store heater upright in an
Gas valve may be OFF Turn the gas valve ON Fuel tank empty Refill LP gas tank Orifice blocked Clean or replace orifice Air in supply system Purge
Tools neededAdjustable opening 8’’longPhilips head screwdriverLeak detection solution (instructions on how toFor questions, replacement parts, service
3Wheel assembly
NOTE: PLEASE READ THE FOLOWING SAFETY RULES WARNING:This appliance must only be used outdoors.Using this product in an enclosed area may causeinjury,d
ATTACHING WHEEL ASSEMBLY Step 1 1-1. Locate Wheel Assembly (24) and 2 nuts/bolts contained in plastic bag with Wheel Assembly (Fig. 1). Step 2 2-
WARNING:Proper assembly is the responsibility of the installer.Step 1 Attach post mounts to cylinder basePlace the post mounts on the top of cylinder
Step 2Attach post support to post mountsStep 3Attach lower post to base assemblyAttach the lower post to the post mounts using4pcs M6x10 bolts.ASSEMB
Step 4Attach upper post to lower postScrew the upper post to the lower post asillustrated by turning in a clockwisedirection until securely tightened.
Step 6Attach double pointed bolts to head assemblyAttach M8x90 double pointed bolts (3pcs) to head assembly.Step 7Attach the gas hose to head assembl
Kommentare zu diesen Handbüchern